Plain press factory

The noise generated by plain press is too loud and seriously affects daily life.How to reduce the noise pollution of plain press?Below,the plain press factory will share with you.

There are many noise control methods in the punching workshop,generally including the following:using low-noise production equipment and focusing on solving the problem of noise sources.Using servo presses instead of traditional mechanical presses can control the noise of stamping below 75dB,achieving very ideal results.

Adjust job management and workpiece processing technology.Reduce the time that operators are affected by noise through job rotation;The same parts processed in 5 steps produce less noise than those processed in 4 steps.Isolate the transmission path of noise and reduce the reverberation time in the workshop.Due to the long reverberation time and slow sound attenuation in the workshop,the more noise the sound source transmits to each receiving point through reflection,it is necessary to use special media to block the propagation path of noise and reduce the damage of noise to the health of operators.
Due to the inability of existing stamping lines to make large-scale changes in equipment and processes,isolating the propagation path of noise is the main means and basic idea for noise reduction in stamping lines,given that the equipment,processes,and surrounding environment have been determined.
The above is an introduction to reducing the noise of plain press.In actual production and processing,we should not only pay attention to the impact of pneumatic bed punching noise on us,but also pay attention to some dangerous things to be aware of during workshop construction.